Grow Room Automation NYC
TrolMaster Climate & Irrigation Control
Commercial TrolMaster installation and grow room automation for cultivation facilities across NYC.
Indoor cultivation only pays back when the environment is airtight. Temperature, humidity, VPD, CO2, irrigation, and lighting schedules have to hold inside tight tolerances 24/7 — and the wiring, sensor placement, and alarm logic have to be right the first time. That's what we build.
We install TrolMaster Hydro-X, Hydro-X Pro, and Hydro-X Plus systems end-to-end — main controllers, 3-in-1 and 4-in-1 sensors, PAR sensors, temperature device stations, humidity stations, CO2 regulators, irrigation stations, and 0–10V lighting control adapters for every major fixture. We handle the structured low-voltage wiring, the mounting, the commissioning, and the mobile app setup.
Whether you are outfitting a single 1,000 sq ft grow tent cluster, a multi-room veg/flower cultivation facility, or a research greenhouse, we design the TrolMaster layout around your crop plan — not a generic catalog. You get tight VPD control, redundant alarm paths, and remote visibility from anywhere.
What's Included
From Site Walk
to Cut-Over.
Room Assessment
We walk your grow space and map zones, airflow, lighting, HVAC, CO2 supply, and irrigation layout. We identify sensor placement, controller location, and wiring paths before quoting.
System Design
We select Hydro-X, Hydro-X Pro, or Hydro-X Plus based on zone count and device load. We spec sensors (MBS-Pro 4-in-1, MBS-TH, MBS-S8 CO2, MBS-PAR), device stations, and lighting adapters for your exact fixtures.
Wiring & Mounting
Low-voltage control cable pulled clean and labeled. Controllers, sensors, and device stations mounted in the correct positions — sensors at canopy height, away from direct airflow, shielded from light.
Commissioning
We program temperature, humidity, VPD, CO2, and lighting targets per room. Day/night cycles, ramp schedules, alarm thresholds, and safety lockouts configured and bench-tested against your setpoints.
Training & Support
Your cultivation team gets a live walk-through of the controller, the mobile app, alarm handling, and data export. Ongoing remote support and on-site service for firmware updates and expansion.
FAQ
Yes. We are an authorized installer of the full TrolMaster product line — Hydro-X, Hydro-X Pro, Hydro-X Plus, Aqua-X, Carbon-X, and the Tent-X series. We handle the wiring, sensor placement, commissioning, and staff training as a single turnkey scope.
Hydro-X (HCS-1) is the entry system, supporting up to 16 device stations for small single-zone grows. Hydro-X Pro (HCS-2) adds a larger device capacity and supports the MBS-Pro 4-in-1 sensor. Hydro-X Plus (HCS-3) is the flagship with the highest device count and multi-room management. We recommend the platform based on your room count and crop plan.
Yes. That is the core value of the platform. One Hydro-X main controller with the right device stations and adapters unifies temperature, humidity, VPD, CO2, lighting (0–10V dimming for most commercial fixtures), dehumidifiers, pumps, irrigation valves, and alarm logic under a single schedule and mobile app.
Yes. We can tie TrolMaster environmental alarms into our intrusion and video platforms — so an over-temperature event or CO2 fault triggers a camera snapshot, a central-station notification, and a push alert to the cultivation manager and security team. One integrated stack, not three disconnected systems.
Yes. We routinely retrofit cultivation facilities that started with thermostats, plug-in controllers, or legacy systems. We plan the cut-over so you keep the environment stable during installation — usually zone-by-zone to avoid crop stress.
Ready to Install
Grow Room Automation?
Free on-site assessment for grow room automation across all five boroughs.